
PIAA 19615 9005 (HB3) Xtreme White Plus
$64.57
Buy on Amazon →
Used for: Headlight Bulb High Beam
Used for: Headlight Bulb Low Beam
Used for: Back Up Reverse Light Bulb
Used for: License Plate Light Bulb, Map Light Bulb
Used for: License Plate Light Bulb, Map Light Bulb
Used for: Turn Signal Light Bulb Rear
Used for: Dome Light Bulb
Used for: Dome Light Bulb
Used for: Trunk or Cargo Area Light
Used for: Trunk or Cargo Area Light
Used for: Vanity Mirror Light Bulb
This 2020 Buick Encore bulb size page is designed to help you verify the correct bulbs by lighting position, so you can match the right part before you buy. Whether you are replacing a headlight, tail light, turn signal, or interior lamp, the layout makes it easier to compare each location on the vehicle with the bulb type listed for that spot.
The 2020 Buick Encore uses a mix of LED and halogen-style bulb locations depending on the lamp and configuration. That means some exterior lights may be listed as LED assemblies, while other serviceable positions use replaceable bulbs such as 9005, H11, 921, 7440A, 2825/98, 194/7441, 6411/6428, and 6612F. Checking by position is the safest way to avoid ordering the wrong bulb.
Fitment can vary by trim, lighting package, market, and body style, so it is smart to confirm the installed bulb before purchasing. Some Encore lighting positions may be LED on one version and a replaceable bulb on another, and aftermarket LED conversions can also change the fit or beam pattern. If you are upgrading from halogen to LED, make sure the bulb base, depth, and connector match, and always compare the old bulb or housing label before you order.
The listed low beam bulb is H11 for the 2020 Buick Encore when the vehicle uses a replaceable low beam bulb. Some lighting setups may be LED instead, so confirm the installed lamp type before buying.
The listed high beam bulb is 9005 on versions that use a serviceable halogen bulb. Other configurations may use LED headlight units, so the exact fit depends on trim and lighting package.
The page lists the daytime running light as LED. In many cases that means the DRL is part of an LED lamp assembly rather than a simple plug-in bulb, so replacement may differ from a standard bulb swap.
The rear turn signal bulb is listed as 7440A. If your vehicle has LED rear lighting, verify the actual installed part before ordering, since some trims can differ.
The back up reverse light bulb is listed as 921. This is a common service bulb, but it is still best to check the existing bulb and socket style for confirmation.
The license plate light bulb is listed as 2825 or 98. Either size may appear depending on the specific lamp setup, so match the old bulb when possible.
The map light bulb is listed as 2825 or 98, and the dome light bulb is listed as 6411 or 6428. These are common interior bulb sizes, but the exact fit can vary by trim.
The trunk or cargo area light bulb is listed as 194 or 7441. Check the socket and the old bulb, since either size may be used depending on the lamp design.
The page lists the brake light bulb, tail light bulb, and center high mount stop light bulb as LED. In many cases these are LED assemblies rather than replaceable bulbs, so replacement may require the full lamp unit.
The front turn signal light bulb and parking light bulb are listed as LED. That usually means the light is integrated into the assembly, so you should confirm whether your Encore has a serviceable bulb or a sealed LED unit.
Both the front side marker light bulb and rear side marker light bulb are listed as LED. Because these can be integrated into the lamp assembly, checking the installed part is important before ordering replacements.
Use the bulb position on the vehicle, compare it with the chart, and confirm the installed bulb or housing label before purchase. This is especially important on the Encore because trim and lighting package differences can change whether a position uses LED or a replaceable bulb.