Used for: Headlight Bulb High Beam
Used for: Headlight Bulb Low Beam
Used for: Back Up Reverse Light Bulb
Used for: License Plate Light Bulb
Used for: Side Marker Light Bulb Front
Used for: Turn Signal Light Bulb Front
Used for: Courtesy Light Bulb
Used for: Courtesy Light Bulb
Used for: Dome Light Bulb, Engine Compartment Light Bulb, Trunk or Cargo Area Light
Used for: Dome Light Bulb, Engine Compartment Light Bulb, Trunk or Cargo Area Light
Used for: Map Light Bulb
This 2012 Porsche 911 bulb size guide helps you verify the correct replacement bulbs by lighting position, so you can match the right part to the right socket before you buy. Because the 911 can vary by trim, body style, and lighting package, it is important to confirm each bulb location individually instead of assuming every car uses the same setup.
Use this page to check common exterior and interior bulb fitments for the 2012 Porsche 911, including headlight, tail light, turn signal, courtesy, map, dome, trunk, engine compartment, and license plate lights. The chart is organized to make replacement easier whether you are servicing a single failed bulb or planning a full lighting refresh.
Fitment can change with market, trim, and factory equipment, especially on cars with different headlight systems or LED lighting packages. Some positions on the 2012 Porsche 911 use LED assemblies, while others use replaceable bulbs such as H11, D2S, 6411/6428, 6418, 2886X, 7506, 2821, 2825/98, or PH24WY depending on location. If you are considering aftermarket LED conversions, make sure the bulb type, base, polarity, and beam pattern are compatible with the housing. The safest approach is to compare this guide with the bulbs already installed in your vehicle before ordering replacements.
It helps you identify the correct bulb size by lighting position, such as headlight, tail light, interior light, or license plate light. That makes it easier to replace the right bulb without guessing.
No. Trim level, body style, market, and lighting package can change the bulb setup. Always verify the exact position on your car before purchasing replacement bulbs.
The listed low beam bulb is D2S. Some vehicles may have different lighting equipment depending on factory configuration, so confirm what is installed before replacing it.
The listed high beam bulb is H11. Check the headlamp housing and existing bulb to make sure your car matches this fitment.
The listed front turn signal bulb is PH24WY. This is one of the key bulbs to verify if you are replacing a front signal lamp.
The rear turn signal bulb is listed as LED on this page. Because it is an LED setup, replacement may involve the complete LED unit rather than a standard replaceable bulb.
The license plate light bulb is listed as 6418. This is a common exterior bulb position that is easy to check and replace when needed.
Those interior and utility light locations are listed with 6411 and 6428. These bulbs are used in multiple positions, so confirm the exact socket before ordering.
The map light bulb is listed as 2886X. If both map lights are dim or out, it is a good idea to compare the working side before replacing them.
The back up reverse light bulb is listed as 7506. Make sure the replacement matches the original base and output before installation.
Some positions are already listed as LED, while others use halogen or HID-style bulbs. If you want to convert a non-LED location, check fitment, polarity, and housing compatibility to avoid warning lights or poor beam performance.
Yes. That is the best way to confirm the exact fitment, especially on a Porsche 911 where equipment can vary by market and package. Matching the installed bulb helps prevent ordering the wrong part.
