
Marsauto M1C H11 LED Fog Light Bulbs, 30000LM 6000K Cool ...
$17.99
Buy on Amazon →
Used for: Fog Light Bulb Front
Used for: Fog Light Bulb Front
Used for: Headlight Bulb High Beam and Low Beam
Used for: Back Up Reverse Light Bulb
Used for: Brake Light Bulb, Tail Light Bulb Lower
Used for: Center High Mount Stop Light Bulb, License Plate Light Bulb
Used for: Center High Mount Stop Light Bulb, License Plate Light Bulb
Used for: Parking Light Bulb
Used for: Side Marker Light Bulb Front
Used for: Tail Light Bulb Upper
Used for: Turn Signal Light Bulb Front Inner
Used for: Turn Signal Light Bulb Front Outer
Used for: Turn Signal Light Bulb Rear
Used for: Map Light Bulb
Used for: Map Light Bulb
Used for: Trunk or Cargo Area Light
This page helps you verify the bulb sizes for the 2009 Lincoln Navigator by lighting position, so you can match the right replacement to the right socket. Because trim and lighting packages can vary, it is smart to confirm each bulb before you buy, especially for exterior lamps and any vehicle with upgraded lighting.
Use the chart below as a practical reference for common service points such as headlights, turn signals, brake lights, license plate lights, and interior lamps. The 2009 Lincoln Navigator uses different bulb types depending on location, so checking by position is the best way to avoid ordering the wrong part.
Fitment can change with trim level, market, body style, and factory lighting package, so the same 2009 Lincoln Navigator may not use the exact same bulb in every position. Some locations may also be affected by halogen versus LED setups or by aftermarket conversions, which can change the bulb style or the way the lamp housing works. Before purchasing, compare the bulb in your vehicle, inspect the base and connector, and make sure the replacement matches the installed part rather than relying only on a general listing.
The chart lists D3S for both the high beam and low beam headlight bulb position on the 2009 Lincoln Navigator.
Front fog light fitment is listed as H11 LED or H16 LED, depending on the vehicle’s setup and lighting package.
The back up reverse light bulb is listed as 921.
The center high mount stop light bulb is listed as 168 or 917.
The license plate light bulb is listed as 168 or 917.
The front parking light bulb is listed as 3157, and the front side marker light bulb is listed as 194NA.
The front outer turn signal light bulb is listed as 906NA.
The front inner turn signal light bulb is listed as 3157A.
The rear turn signal light bulb is listed as 4057.
The brake light bulb is listed as 4057R.
The upper tail light bulb is listed as 906, and the lower tail light bulb is listed as 4057R.
The map light bulb is listed as 2825 or 98, and the trunk or cargo area light is listed as 578.
For exterior lighting, replacing bulbs in pairs is often a good idea so brightness and color stay consistent, especially on headlights, parking lights, and turn signals.
Yes, some positions may accept LED replacements, but fitment depends on the housing, connector, and local lighting setup. Always confirm the exact bulb type and check whether the LED is compatible with the lamp assembly.