
Marsauto M1C H11 LED Fog Light Bulbs, 30000LM 6000K Cool ...
$17.99
Buy on Amazon →
Used for: Fog Light Bulb Front
Used for: Fog Light Bulb Front
Used for: Headlight Bulb High Beam and Low Beam
Used for: Back Up Reverse Light Bulb
Used for: Brake Light Bulb, Tail Light Bulb Lower
Used for: Center High Mount Stop Light Bulb, License Plate Light Bulb
Used for: Center High Mount Stop Light Bulb, License Plate Light Bulb
Used for: Parking Light Bulb
Used for: Side Marker Light Bulb Front
Used for: Tail Light Bulb Upper
Used for: Turn Signal Light Bulb Front Inner
Used for: Turn Signal Light Bulb Front Outer
Used for: Turn Signal Light Bulb Rear
Used for: Map Light Bulb
Used for: Map Light Bulb
Used for: Trunk or Cargo Area Light
This page helps you verify the bulb sizes for the 2011 Lincoln Navigator by lighting position, so you can match the right replacement before you buy. Whether you are changing a headlight, tail light, license plate bulb, or interior lamp, checking the exact location is the easiest way to avoid ordering the wrong part.
The 2011 Lincoln Navigator uses several different bulb types across the front, rear, and cabin lighting. Because trim level, lighting package, market, and body style can affect fitment, it is smart to compare the bulb chart for your specific vehicle and confirm the installed bulb before replacement.
For best results, use this guide as a starting point and then inspect the bulb currently in the vehicle. Some 2011 Lincoln Navigator models may use different lighting equipment depending on trim or factory package, and aftermarket LED conversions can change the bulb type or require additional components. Halogen and LED replacements are not always direct swaps, especially in fog lights, exterior signal lamps, and headlight assemblies. If you are unsure, remove the old bulb and match the base, connector, and shape before ordering.
The listed headlight bulb for both high beam and low beam is D3S. Always confirm your headlamp setup before buying, since lighting equipment can vary by market and package.
The back up reverse light bulb is 921.
Both the center high mount stop light bulb and the license plate light bulb are listed as 168 or 917.
The front parking light bulb is 3157.
The front inner turn signal light bulb is 3157A, and the front outer turn signal light bulb is 906NA.
The front side marker light bulb is 194NA.
The front fog light bulb is listed as H11 LED or H16 LED, depending on the setup shown for the vehicle.
The rear turn signal light bulb is 4057, the brake light bulb is 4057R, and the lower tail light bulb is also 4057R. The upper tail light bulb is 906.
The map light bulb is listed as 2825 or 98, and the trunk or cargo area light uses 578.
No. Trim level, lighting package, body style, and market can change the bulb fitment. That is why it is important to verify the exact lighting position on your vehicle.
In many positions, yes, but fitment can be different from the original halogen bulb. LED upgrades may need the correct base, polarity, or extra hardware, and some exterior lamps may not perform the same as factory bulbs.
Check the bulb location, the part number or base on the installed bulb, and whether your Navigator has factory halogen or LED equipment in that position. Matching the old bulb is the safest way to confirm fitment.