
PIAA 19618 Xtreme White Plus
Buy on Amazon →
Used for: Headlight Bulb High Beam and Low Beam
Used for: Back Up Reverse Light Bulb, Parking Light Bulb, Turn Signal Light Bulb Front, Turn Signal Light Bulb Rear
Used for: Brake Light Bulb, Tail Light Bulb
Used for: License Plate Light Bulb
Used for: License Plate Light Bulb
Used for: Side Marker Light Bulb Front
Used for: Side Marker Light Bulb Rear
Used for: Stepwell Light Bulb, Courtesy Light Bulb
Used for: Automatic Transmission Indicator Light Bulb
Used for: Dome Light Bulb
Used for: Engine Compartment Light Bulb
Used for: Map Light Bulb, Trunk or Cargo Area Light
This 2010 Jeep Wrangler bulb size page helps you verify the correct replacement bulb by lighting position, so you can match the right fit before you buy. Whether you are replacing a headlight, tail light, license plate lamp, or interior bulb, checking the bulb chart by location is the easiest way to avoid ordering the wrong part.
The 2010 Jeep Wrangler uses a mix of exterior, interior, and utility bulbs, and some lighting details can vary by trim, body style, market, or factory package. Use this guide to compare each bulb position on your Wrangler and confirm the size for the exact lamp you need to replace.
For best fitment, always compare the bulb chart with the bulb already installed in your Jeep, especially if your Wrangler has been modified or converted to LED lighting. Trim and lighting package differences can affect certain positions, and aftermarket housings may change the required bulb type even when the vehicle year is the same. If you are upgrading from halogen to LED, make sure the replacement bulb is compatible with the socket, polarity, and any load or flash-rate issues that can happen on turn signals or brake lights. Before purchasing, remove the old bulb and check the marking on the base whenever possible, since that is the most reliable way to confirm fitment.
The 2010 Jeep Wrangler uses an H13 bulb for both the high beam and low beam headlight positions.
The brake light bulb size listed for the 2010 Jeep Wrangler is 3157R.
The tail light bulb size for the 2010 Jeep Wrangler is 3157R.
The front turn signal light bulb size for the 2010 Jeep Wrangler is 3157.
The rear turn signal light bulb size for the 2010 Jeep Wrangler is 3157.
The back up reverse light bulb size for the 2010 Jeep Wrangler is 3157.
The license plate light bulb sizes listed are 194 and 7441.
The dome light bulb size listed for the 2010 Jeep Wrangler is 912.
The map light bulb and trunk or cargo area light bulb are both listed as 578.
The courtesy light bulb and stepwell light bulb are both listed as 906.
The engine compartment light bulb size listed for the 2010 Jeep Wrangler is 561.
Yes, the parking light bulb and front turn signal bulb are both listed as 3157 for this model year.
No. Trim, body style, market, and lighting package can change bulb fitment, so it is important to verify the specific lighting position on your vehicle.
Yes, many owners upgrade to LED bulbs, but fitment and function should be checked carefully. Some positions may need compatible housings or additional hardware to work correctly.
Check the bulb position, confirm the size on the chart, and compare it with the bulb currently installed in your Wrangler before buying.